Oil fitting

[kansasfirstgen]

I didn't trust one turbo off of 1/8 npt..the threaded hole doesnt look that small but you should look at the id of a 1/8 npt jic fitting. it is scary small

 

[bsmith]

Or you could tap to 1/4 npt and run a tee to feed both turbos, then just plug the other port

You think 1/4" would be sufficient for both turbos?

 

[12VALVEADAM]

Or you could tap to 1/4 npt and run a tee to feed both turbos, then just plug the other port

Yeah do you think that would be enough?

 

[kansasfirstgen]

Yeah, I would drill out the inside of the tee though so there is no restriction-- "port" the fittings lol. There is enough material there to drill and tap the aluminum to 3/8 though if you are worried.

 

[12VALVEADAM]

Alright cool, if i take off the oil filter will that be enough to get the shavings out of take the whole thing off?

 

[WUnderwood]

you putting this fitting on your 12 valve, I'm guessing?

 

[bsmith]

Yeah, I would drill out the inside of the tee though so there is no restriction-- "port" the fittings lol. There is enough material there to drill and tap the aluminum to 3/8 though if you are worried.

That's what I was thinking 3/8" to be safe.

 

[12VALVEADAM]

yes 12v and 3/8 sounds good