p pump oil lines and ecm location?

[94adam89]

i started my conversion last night. :rockwoot: Got the cover, pump, cam, and most of the valvetrain back together. Then progress slowed to nothing after a few beers hahaha :Cheer: I've run into a few little things already tho!

my question is where can I get the oil fitting for the block so that I can run a new line to the drivers side of the pump?

does anyone know if this kit comes with both the pump and block fitting?

Cummins VP44 to P7100 Conversion Oil Feed Line

Also what are you all doing with the ecm? Its tight in there. I thought about making a bracket to hang it off the motor a bit? Thanks Everyone! Adam

 

[Triple 7]

I turned my ecm 90* and made some brackets to mount it to the last bolt on the head.

 

[94adam89]

after looking at the picture of that line kit, ive decided that both fittings are included and I will probably just get that kit and be done with it.

I think I've figured out how to mount my ecm. after looking at a handful of pictures on here its pretty clear.