JakeDiesel
New member
- Joined
- Jan 8, 2009
- Messages
- 415
Ive searched about this but have not really found an answer so Ill ask.
I injection pump gear is a press fit to the injection pump, when you pull the gear there is a key way on the shaft but no key way on the gear.
With these 13mm pumps (just an example) taking alot of power to turn do you guy cut a key way in the gear to prevent timing slip?
Thanks Jake.
I injection pump gear is a press fit to the injection pump, when you pull the gear there is a key way on the shaft but no key way on the gear.
With these 13mm pumps (just an example) taking alot of power to turn do you guy cut a key way in the gear to prevent timing slip?
Thanks Jake.