m880cummins
New member
- Joined
- Apr 29, 2013
- Messages
- 142
Good for a rebuild. It came off a Ford F700 12v motor which I rebuilt and put in my crew cab. It is a 180HP pump. I cleaned the pump up, repaired a damaged AFC screw hole and installed. There is evidence of a repair where I fixed screw hole. AFC top also has minor damage in same location. I was able to start my truck with this pump and it ran but off of idle it would sputter and run rough. I investigated by pulling the DVs and looking for any corrosion/dirt but found none. Rack moved fine so not sure what the issue is. It is just the pump, no throttle brackets or shutdown solenoid. Just want to raise a few bucks for a Dual Disc clutch purchase so it has to go. $200
On my engine:
Charlie
On my engine:
Charlie
Last edited: