Putting these up cause they are are too small for the 6.7 I've got almost ready. Turbos are HTT's 62/71/13 & 480/83/1.1. They supported 800hp. I'd call them best suited for 750hp and they are probably the fastest spooling 750hp. Easily made 40psi by 2,000 RPM. Unbenounced to me, the primary(480) turbine was quite a bit smaller than I had thought and is the main limiter in this set. It was sold to me as a 80/96/1.1 but is in fact the 83/1.1 turbine. Toss a real primary on it and these will support 900hp. Any standard s400 will fit right into the kit as the vband on the 480 is in same location as a box s400.
Secondary is a t3 inlet/hx40 outlet with 4" hot pipe. 13cm SS dual puck wategated housing from HTT and its polished. Stainless Diesel spring gate included with extra spring. Long ago when I was a noob I had to grind the housing to clear the spool valve I was trying at the time. Still functions perfectly and doesn't leak at all. Grinding is hidden from view when set is installed.
Cold pipe has a bung for independent boost reading of the primary.
Polished SD manifold included. Manifold studs included as well.
Will sell primary turbo seperately. Have another thread on that. Listed at $800
Asking $3500 shipped in 48. Will ship via UPS. Paypal accepted. I'd prefer to split the fees with buyer. Fairly firm at this price because I will adapt the piping to my new turbos if these don't sell.
Thermal Zero Primary blanket not included. Oil lines can be included or price reduced. Primary drain is a Fleece setup with -10 fittings.
Downpipe is a 4" vband next to the trans.
Primary turbine housing has been smoothed.
Secondary is a t3 inlet/hx40 outlet with 4" hot pipe. 13cm SS dual puck wategated housing from HTT and its polished. Stainless Diesel spring gate included with extra spring. Long ago when I was a noob I had to grind the housing to clear the spool valve I was trying at the time. Still functions perfectly and doesn't leak at all. Grinding is hidden from view when set is installed.
Cold pipe has a bung for independent boost reading of the primary.
Polished SD manifold included. Manifold studs included as well.
Will sell primary turbo seperately. Have another thread on that. Listed at $800
Asking $3500 shipped in 48. Will ship via UPS. Paypal accepted. I'd prefer to split the fees with buyer. Fairly firm at this price because I will adapt the piping to my new turbos if these don't sell.
Thermal Zero Primary blanket not included. Oil lines can be included or price reduced. Primary drain is a Fleece setup with -10 fittings.
Downpipe is a 4" vband next to the trans.
Primary turbine housing has been smoothed.
Last edited: