PSDPlayer
Captain Negativity!
- Joined
- Apr 22, 2006
- Messages
- 3,284
So since I would be needing an SFI bellhousing for a Torqshift. I went ahead and made one. This is the 5R110 Bellhousing being printed in plastic for it to be cast into aluminum to be sent out for SFI approval. This bellhousing will allow compliance for NHRA to actually run at one of there events if you are going fast enough which is what we are rapidly approaching. Dodge Pattern is done. GM pattern is done. These will fit our converters. This will also allow easy swapping of transmissions behind other engines.
All of this started in Solidworks. Then I was able to print them on my 3D printer.
Removed the bell...
Printing them in 3D out of plastic to be used to make the casting mold...
Some Assembly Required...
Here are some more pics... Printed all 5 pieces. Sprayed them with some paint cause we ran out of white and had to use yellow and it looked kinda funny...
This will also allow an easy way to bolt a 4R100 to the back of your 6.0L if you are so inclined and will meet SFI 30.1 for a flex plate shield.
All of this started in Solidworks. Then I was able to print them on my 3D printer.
Removed the bell...
Printing them in 3D out of plastic to be used to make the casting mold...
Some Assembly Required...
Here are some more pics... Printed all 5 pieces. Sprayed them with some paint cause we ran out of white and had to use yellow and it looked kinda funny...
This will also allow an easy way to bolt a 4R100 to the back of your 6.0L if you are so inclined and will meet SFI 30.1 for a flex plate shield.