I have the stage 3 mpg/max kit installed correctly per instructions and everything seems fine. Set 15psi/25/40psi on the power mode on the controller. Everything seems fine until injecting begins! The controller unit blinks rapidly between Snow Performance screen and psi/egt/%injected screen????? Then, if I boost greater than 40-50psi the controller unit shuts off and the little red right hand corner light comes on. I have to turn off the on/off switch to reboot.!!!!! Please tell me this is not normal!!:nail:
Snow performance controller problems
- Thread starter gavngrav
- Start date
Extended Power
New member
- Joined
- May 19, 2006
- Messages
- 2,978
Same thing happened to mine...display would flash, and nothing happened...
The switch was.the problem on mind too.
The switch was.the problem on mind too.