Valve body ?

it will fit, but will not "work"

the RH is hydraulically governed by a sinning governor assembly in the tail housing.

now, will a constant pressure full manual RH VB work? that is a questions I'd like to know.
 
it will fit, but will not "work"

the RH is hydraulically governed by a sinning governor assembly in the tail housing.

now, will a constant pressure full manual RH VB work? that is a questions I'd like to know.

I've always wondered this too, full manual meaning you cannot just slap it in drive and go correct? If so I don't see why not seeing as it doesn't need governed.
 
The shifter stem is a different size. So no, it's not a direct fit without boring it or a sleeve.
 
^good call, never thought of that

other than that, does an RH full manual VB require a gov signal?
 
How do you set max line pressure though without some sort of input, IE: TV cable?
 
I have a manual RH vb in a RE case, the shifter stem in the same size, but the electrical connector is smaller on the RH. We had to make a sleeve so it would seal.




Sent from phone
 
I have a manual RH vb in a RE case, the shifter stem in the same size, but the electrical connector is smaller on the RH. We had to make a sleeve so it would seal.




Sent from phone
Good catch! I was thinking of the wrong hole.
 
Back
Top