Wanted 88 to 95mm turbo

Powerstroke Cowboy

Powerstroke Cowboy

Boost is energy held back
Joined
Feb 22, 2011
Messages
639
Howdy, I would like to buy a turbo that has a 88mm to 95mm Compressure Wheel inducer..

Thanks For looking and have a great day.
 
Check nothing!! You need to tell us WAY more info than a 88-95. What A/R what turbine, what flow rate are you looking for.

This for a twin kit? What truck? Motor? Gears? Tranny? Elevation? Etc help us out!
 
Last edited:
Just like the post says 88mm to 95mm inducer on the compressure side.. I dont care about the exhaust side to much... I would like it to flow 1800 to 2500 cfm. or in the 160 to 200 lb/min... I will be putting it on a 97 Powerstroke :)
 
a6898ddc-8183-1af4.jpg
a6898ddc-8195-946b.jpg
a6898ddc-81a3-d1fa.jpg
96mm inducer
 
Cowboys4Christ said:
Just like the post says 88mm to 95mm inducer on the compressure side.. I dont care about the exhaust side to much... I would like it to flow 1800 to 2500 cfm. or in the 160 to 200 lb/min... I will be putting it on a 97 Powerstroke :)
Click to expand...

You need to care about the exhaust side, your looking at about $2000-3000 depending on the charger.
 
TMONEYDIESEL said:
You need to care about the exhaust side, your looking at about $2000-3000 depending on the charger.
Click to expand...

I might not use the exhaust side... I might just take it off and make the turbo into a prochager... And run it from a Pulley that comes off the crank..

I would have to make a gear box, to bolt in place of the exhaust housing and exhaust wheel....
 
I've got an HX82...3.4" inducer...but it needs a compressor. $500, you pay the shipping.


The compressor is useable, bearings are good....but to make it "right" it needs a new wheel. It was running as is.

Chris
 
You must log in or register to reply here.
Back
Top