What are your thoughts about this motor build?

[Light It Up]

What do you guys think about this setup? Is there anything you would add or not use?
12v.
Custom Open Bowl Pistons with 42cc bowl
Custom built injectors for correct spray for bowls. 500HP injectors
teflon bearings
Shied Diesel custom Profile camshaft
billet Cr tappets
Custom 13mm ball chromolly pushrods
big cast head with 5 angle valve job 60lbs springs and fire rings
A1 head studs
Haisley Machine rear Bypass Plate
haisley machine billed tappet cover, rear block water releif
cyro treated rods
Shied Diesel .120 Stainless lines
Shied Diesel Billet Intake plate
Custom Intake with 3x8 opening

Thanks

 

[DEZLFREK]

you will have to run a different valve spring for sure

 

[Light It Up]

Forgot to put those up there. Bottom end is also balanced.

 

[Hurley]

well, what are your overall goals?

 

[Joker12valve]

Where do you get one of these big cast heads? sounds like a nice build what you looking to do with the truck, twins, drag, pulling. that helps with what the final out come will be.

 

[TravisG]

Where do you get one of these big cast heads?

Duh! At the really big cast head store Joe!

500 horse injectors? Do tell. I'm not bagging on ya, you just have some pretty technical terms and then "big cast head and 500 horse injectors" after that.

 

[cumminsman315]

instead of 500hp injectors, xx lpm would be a more ideal measurement

 

[Kronic_187]

what about gph ??

 

[cumminsman315]

alot of higher performance injectors use lpm comparison

 

[Light It Up]

This is a motor Im lookin at buying. This is what the guy told me. Its all built. Its gana be used in my puller. I watched the truck run a 12.9 1/4 with 4" lift and 37's.

 

[GOT-Torque]

how much is he asking? PM me if necessary.

I may have another option for you...

 

[Light It Up]

PM sent.