where to set the plate at for the dyno??

pete6030

pete6030

New member
Joined
Jan 27, 2011
Messages
34
ok guys got the truck in my sig and when i got my IP tuned they said with the plate all the way back it would be at 375cc and full forward would be 475cc currently daily driving it i run it at 400, my question is should i go full forward on the dyno? there is no such thing as "putting the fire out" is there? thanks
-max
 
Yes, you can put the fire out, but you have to have a LOT of fuel. Are you going to be on an inertia dyno or load dyno? Either way, I would leave it how you drive it on the street on the first dyno pull, just as a baseline.
 
yes u can "put the fire out" my freinds pulling truck we used that concept when he barried the2000 degree guage do we pushed his plate forward and got them to about 1600
 
Put the plate on your work bench when you leave for the dyno.....
 
Plate????....

Who runs a plate in a 12v,not too many owners with power.
 
well i have no afc so i would like to have some control of the rack
 
AFC was removed when i got the engine, kinda wish it was there though for in town driving
 
You must log in or register to reply here.
Back
Top