SuperiorRam
New member
- Joined
- Dec 5, 2008
- Messages
- 1,239
Im trying to narrow down what w2a to use for my toy truck. I do not want to use a a2a because of the truck setup with removable front end and light weight rear half of the truck. So piping and cooler will run through the cab to the "box" area.
Setup is regular cab first gen 12 valve seth's 575cc p pump,145* 5x18's, 155* slugs, 28.5 degrees, engine supporting stuff: arp fire rings springs push tubes ect. Air has been a 80/96/1.10 feeding a 62/73/14 and has made 97lbs and can get to 1600 fairly soon, but I would like to be able to really hold it power and speed wise but let out sooner than what I would like.
I previously ran a factory intake plate after cooler off of a industrial model (with engine coolant) that worked decent but brought up coolant temps so that got chucked. And a factory second gen unit for a little while and was slightly better at not heat soaking so much.
Old setup:
The new plan/ revision has been to back half, four link and install fiberglass bed sides, tailgate, one piece front end. 14 pt cage and paint but to install the front tubes of the cage I needed to move the twins to a more conventional setup...
I've also been kicking around the idea of the s595/1.15 I have here too...
Setup is regular cab first gen 12 valve seth's 575cc p pump,145* 5x18's, 155* slugs, 28.5 degrees, engine supporting stuff: arp fire rings springs push tubes ect. Air has been a 80/96/1.10 feeding a 62/73/14 and has made 97lbs and can get to 1600 fairly soon, but I would like to be able to really hold it power and speed wise but let out sooner than what I would like.
I previously ran a factory intake plate after cooler off of a industrial model (with engine coolant) that worked decent but brought up coolant temps so that got chucked. And a factory second gen unit for a little while and was slightly better at not heat soaking so much.
Old setup:
The new plan/ revision has been to back half, four link and install fiberglass bed sides, tailgate, one piece front end. 14 pt cage and paint but to install the front tubes of the cage I needed to move the twins to a more conventional setup...
I've also been kicking around the idea of the s595/1.15 I have here too...