little6cylinder
Everything is "fixable"
Thanks, it is fun. Mine is more of a streetable drag truck. It's not cheap, that's for sure.
Drag truck/Street toy build
- Thread starter little6cylinder
- Start date
Thanks, it is fun. Mine is more of a streetable drag truck. It's not cheap, that's for sure.
little6cylinder
Everything is "fixable"
Here's the trac-bar my brother made. I had a 3rd gen bar on it but the truck is too low to run anything except a custom one. I know it wouldn't be good for 4 wheeling because it'll push the axle to the side but the truck has 3 1/2" of total travel. 1 1/2" up and 2" down so I'm not worried about that. It's adjustable and really solid. Plus it doesn't go off the road. The dirtiest this thing will ever get is dust lol
little6cylinder
Everything is "fixable"
Here's my only progress last night. :hehe: it's comin along slowly.
It looks really close to the charge pipe but it's just the angle. There is a little room.
It looks really close to the charge pipe but it's just the angle. There is a little room.
little6cylinder
Everything is "fixable"
Got a little more done tonight. Spent way too long building a new trans dipstick. The old one got in the way of the piping and was kinked.
SuperDave4x4
popcorn playa
Awesome build and that engine looks beautiful!
little6cylinder
Everything is "fixable"
Thanks guys.
Those tires are 285/60/18. They measured out at like 30.4 inches. It has 28x14.5 16's for racing though.
WhiteKnight
New member
Subscribed..cool build, nice work!
little6cylinder
Everything is "fixable"
I'll look for some. I've ran a few things from them. The particulate filter and a few of their gates. It has all worked really good.
Thanks, I've been thinking of getting a torchmate plasma table or something similar. The time custom brackets and flanges take are rediculous.
Last edited:
little6cylinder
Everything is "fixable"
Thanks, It was roughly 6350 with me in it last time I weighed it. After all the stuff I've pulled off this time around, along with the aluminum dash I'm guessing it'll be 6000ish. Maybe a little under. Then after the cage I'm shooting for just over 6k.
Cummins12Club
Happy Dinosaur
Sounds like a sweet supper street set up
little6cylinder
Everything is "fixable"
That's the plan. We'll see how it does.
Cummins12Club
Happy Dinosaur
Well let us know, you have any idea what kind of power it's making at the crank?
little6cylinder
Everything is "fixable"
With a 12mm dropping fuel psi and a 66/83 (fuel only)it made 864hp at the wheels so I believe that's roughly 1000 at the crank. Now it's got more fuel, a lot more turbo:evil, and a lot of nitrous. *nx* If it's not 1000-1100hp at the wheels it will have problems. :hehe: with a 13mm I'm hoping for 1300+
Cummins12Club
Happy Dinosaur
Should do well in supper street good luck to ya!