Budget Beater!

no build thread for me, not doing anything special or much different that TTR_21

yeah i'm running large twins and 5X20ish injectors
 
1552 CFM from a 74.6mm of pure greatness. The 1.25 turbine housing is going to be fun!

ImageUploadedByTapatalk1361070009.295243.jpg
 
Holes Filled

ImageUploadedByTapatalk1361590272.621140.jpg

Tapper Cover Beater Style

ImageUploadedByTapatalk1361590351.448626.jpg

Mocking Up The Fuel Pumps

ImageUploadedByTapatalk1361590499.418143.jpg
 
I could call mine a budget beater but who has a budget in power? Im surprised you didnt go with a bigger cam what needs flycuts.
 
I'm running my setup a little different since ill be driving it to every event. Titanium will feed main port on injection pump and be controlled with boost compensated regulator. HPFP will feed front port on injection pump and be controlled the same way but only be used when I'm at the track. HPFP powered by a switch in cab.
 
I'm running my setup a little different since ill be driving it to every event. Titanium will feed main port on injection pump and be controlled with boost compensated regulator. HPFP will feed front port on injection pump and be controlled the same way but only be used when I'm at the track. HPFP powered by a switch in cab.

well look at you getting all fancy
 
Industrial Injection 5x.018 SAC injectors

ImageUploadedByTapatalk1362107439.925375.jpg

BD T-3 to T-4 Diverter Valve

ImageUploadedByTapatalk1362107492.053473.jpg

All put together

ImageUploadedByTapatalk1362107533.624179.jpg
ImageUploadedByTapatalk1362107555.608656.jpg
 
^^^ Few words of advice on the diverter: 1) make sure you run fuel injection hose or wastegate hose rated for the boost and heat you will see; 2) make sure your clamping system or fastening system does not have the ability to allow the air hose to blow off; and 3) get the air to the actuator from the cold side (post intercooler) to avoid any excessive heat to the actuator and hose. Good luck!
 
Back
Top