Ghostman
24v crazy
- Joined
- Aug 24, 2012
- Messages
- 2,819
Well basically got a stock unit here. Just went through it tonight except for the OD. I'll look at that later. Trading some parts with Lavon at Firepunk who has been really helpful. He'll be sending me some billet goodies. I noticed that everything looked pretty good for the most part. I thought both of the 47RH planets were 4 gear but the front planet was a aluminum 5 gear? I have read almost every single transmission build thread on here BTW.
Plan on:
Billets servos
Billet accumulator
Billet front anchor, strut, 4.4 apply lever
"Junker Drag Truck" clutch pack mods
5 gear steel planets
Replace all bushings, seals, gaskets, etc
Looking for a good deep pan
Not sure yet on shafts or TC
Trying to figure who can build a reverse pattern full manual valve body besides suncoast, Darren Morrison might be able to, I'll have to call him.
Here's some pics:
I thought there was suppose to be some o-rings here along with the steel rings?
Not sure how thick the front band is suppose to be, but it looks a little thin. May replace it. Recommendations?
5pinion
Is this bad? The scoring?
This bushing is looks kind of worn. This side rides against the 4 pinion where it's scuffed.
5 gear is scuffed
How does this look?
Rear band looks burnt?
Is OD piston retainer look ok?
Front clutches(direct), four clutches four steels look brand new, expected since it does the shifting, says Raybestos on clutches
Rear clutches look used, four clutches and four steels
Thanks for any and all feed back.
Any truth to drilling the holes in the intermediate shaft slightly larger to help feed clutch packs planets better? Any other little secrets or tips are appreciated.
Sent from my iPhone using Tapatalk
Plan on:
Billets servos
Billet accumulator
Billet front anchor, strut, 4.4 apply lever
"Junker Drag Truck" clutch pack mods
5 gear steel planets
Replace all bushings, seals, gaskets, etc
Looking for a good deep pan
Not sure yet on shafts or TC
Trying to figure who can build a reverse pattern full manual valve body besides suncoast, Darren Morrison might be able to, I'll have to call him.
Here's some pics:
I thought there was suppose to be some o-rings here along with the steel rings?
Not sure how thick the front band is suppose to be, but it looks a little thin. May replace it. Recommendations?
5pinion
Is this bad? The scoring?
This bushing is looks kind of worn. This side rides against the 4 pinion where it's scuffed.
5 gear is scuffed
How does this look?
Rear band looks burnt?
Is OD piston retainer look ok?
Front clutches(direct), four clutches four steels look brand new, expected since it does the shifting, says Raybestos on clutches
Rear clutches look used, four clutches and four steels
Thanks for any and all feed back.
Any truth to drilling the holes in the intermediate shaft slightly larger to help feed clutch packs planets better? Any other little secrets or tips are appreciated.
Sent from my iPhone using Tapatalk