Recent content by DIESEL_POWER

Does anyone here know the BW sxe 400 series compressor nut torque spec? NM or Ft lbs is fine. Thanks

Ok so I have a LML, and got a built trans, all is well except one thing, it goes into reverse rougher than it should. Almost like a soft slam into reverse. I was told by the builder it was normal, but it's so bad that the engine down pipe hits the fire wall on occasion because of this when out...

I have two fully loaded heads, over size valves, oring'd, custom spec fully ported with flow sheets. $5500. Obo I have a spare head same as above loaded and oring. Needs one injector cup to fix blow through I had when a injector failed. All else is perfect and flat. I can fix for a fee...

We are the 2016 Nhrda national and world champions!!! Also ran a 6.78 at 200!!! First Electronic diesel engine to run 200mph!!! Great day for us, so thankful! Special thanks to all our sponsors and friends/family. My beautiful wife and awesome son. The Lord Jesus Christ #Flopro...

200k on it, all stock. Needs Trans or trans parts, don't know. DSG Auto clutch 6 speed trans I'll let go for $2500 as is. Or $6500 if i fix it. Loaded leather, power seat, sun roof. Ect well maintained 50 mpg!

We did it!, ran the first 6 second quarter mile in a duramax also won The gateway nhrda event! So glad we accomplished such a feat Special thanks to all our sponsors and friends/family. The Lord Jesus Christ #Flopro #Industrialinjection Borg warner turbo Nitrous express...

260" Gebhardt with 7 slip joints. 24" cage. full carbon Interior with side panels, fully sealed driver area, from foot box to rear of seat. Carbon/glass seat, Full Floater rear housing, top dragster adjustable wing, dual battery mounts, fuel cell mount, weight plate mounts, carbon clip...

How do you figure overall volume of a triple setup. One atmosphere and two manifolds, and also vice versa?

I got the dragster I paid for back in 2014....better late than never. Attention to detail is top of the line. Fits much better than my spitzer. Not sure if I'll stuff a engine in it or sell it, or run a two car team....

I highly recommend this product. Low noise, super smooth, better power and lower egts, looks really nice too.

Honda 2008 Honda crf150r for sale low hours, runs great, Dr dubach full exhaust carbon fiber, boyesen carb mods, Renthal bars and sprockets, and chain and bumpsticks suspension. We never raced it, just rode around atv park and farm. $2200 obo. comes with all gear and parts we have.

On our third full pass, we were blessed with a 7.02 at 195.48 mph in our rail. Unfortunately we have been having stability troubles and have had to abort the run a bit early. Front end is bouncing and dancing around after 1000ft. and it's a bit scary. But Reguarless we are safe and very...

Just went 7.17 at 179 on only our second full passin the rail, pulled chutes early. Only pass of the day for us. Im Really blessed and excited!

Took long enough to build...lol. now im ready to drive.

OK question. If you are making desired boost and drive psi is lower than boost, and there is a wastegate in the system, will a higher A/R Turbine housing make any more power with all else being the same?