Recent content by duck_04

New in the box, 2 available. $385 each, Buyer pays shipping. Sent from my iPhone using Tapatalk Pro

I did a stock rebuild on a 4wd 47re in a 2001 model truck for a friend of mine. The valve body was disassembled and cleaned, and all new electronics and harness installed. The valve body is stockish with only noticeable mods being a shimmed 3-4 accumulator piston, a modified switching valve in...

I've been battling a rail surge issue for quite some time now, and I've tuned around it but now I want to try to get to the bottom of it. Between about 1700 or 1800 and 2100 rpms, I get a horrible rail surge if I have my rail pressure in the tune set at anything over 10K psi. It seems to be...

Smarty JR for a 6.7, $375 to your door.

Manifold sold. Here are pics of the adapter.

I have a PDI 3 piece mainfold and ED T3-T4 adapter with around 10K miles miles on them. No cracks, both in good shape. $400 shipped for the manifold and $90 shipped for the adapter. Or $475 shipped for both. I'll try to get pics up soon.

This is the truck he was thinking about

I have a set of used ARP 425's (247-4202) for a 24 valve for sale. They have been torqued twice. $300 shipped to the lower 48

I have a slighty used silver 64 from II with less than 5K miles on it that I am selling for a friend. It has a new compressor wheel because the other one had a couple nicks it. Shaft play is as tight as new. $1550 shipped

I have some gauges for sale out of my truck. I have the following: 0-30 psi EV mechanical fuel pressure 0-1500 degree EV pyro 0-60 psi EV boost 0-30K psi EV2 rail pressure 100-280 degree EV2 trans temp 3 gauge pod(has a small crack beside top gauge hole) 2 gauge column pod in great shape. I...

Truck sat for 3-4 weeks getting some trans upgrades and got it reinstalled last night. It started without problem and idled fine for 5-10 minutes while I topped the trans fluid off. On my test drive, I make it a half mile down the road at a half throttle take off and it tried to run away. I...

I have 4 of these for sale, part number 167050. They have single scroll T-6 26cm housings. I think they are 76mm compressor inducer, but not positive. I'll have to check on it, or if someone else knows, they can chime in. They are brand new in the box and would make a good primary for a twin...

Need a price on a T-4 Steed Speed with wastegate port and a S471/83/.9 T-4 :thankyou2:

I can't find them, and don't really want to buy all new arms. Anyone have a source for just the bushings?

I have a slighty used Fluid Dampr for a common rail for sale. It is the 9 1/4" one with pulley. It is currently on my truck, but I don't really need it. $350 shipped.