Recent content by hamlin

Which exhaust do you guys prefer? Truck will be deleted at the same time this goes in I am thinking 5in. turbo back stainless, but I want to keep it quiet inside so which brand, muffler. Thoughts?

I have a IH cast head on my truck now and a non-IH cast head sitting on the shelf. I would like to know what the main difference, if any, there is between them.One main concern is if one is superior when it comes to porting. I have came across threads before where the IH heads seem to be the...

I am in need of a dana 80 axle 3.54 gears for srw truck. A limited slip would be great but an open carrier would work also. I live in southeast MN and will drive a reasonable distance to pick up. I would also consider a 70 for the right price to get me by until I find an 80 as well. Thanks!

anyone running them how do they do?

I am in need of some more power my truck currently has 5x.016 contagious inj. pump set at 17*, 4k springs, afc modified for full travel, 2095 rack plug, htt 3 piece man., super hx40, airdog 150, full goerend 47re. Truck also has 3.55 gears and 315 bfg a/t's when I'm hooked to the sled I'm in...

My friend has an 01 dodge probably around 400hp that we cannot get to stop bouncing. the truck is 6 speed, 3.55 gears, fairly new 285 bfg a/t's, pulls in 4lo 4th, everything tried so far does not get rid of the bouncing. In our 7500lb class he can have trac bars and stops and make weight. first...

I have a 96 cclb 2500, my question is where is the best spot to get power for my pillar guage lights? I know i could tap the wire off of the headlight switch, I just want a clean install I don't like cobbling things together. Also, a good ign. power source that will work key forward but not key...

If anyone has one within couple hours of SE MN that you would sell let me know. It's for my friend's truck and in a bit of a hurry to get it fixed. The truck has a nv5600. thanks

Anyone know a place that has them in stock or have a set they would want to sell? seems most places are backordered, Thanks

Hey guys, I am looking at getting into a 2011-12 TDI most likely a 6 speed for my wife. I am looking for any advice or things to look for when looking at one. We are probably going looking this weekend. Any advice or words of wisdom are appreciated! Thank you!

I'm lookin at buying a clutch came out of a nv5600 will it work in a nv4500? Also it's a triple disc south bend would the bell housing need to be modified at all to fit? Thanks

So, I'm starting to round up parts to put an engine together for my truck. It will be a pulling truck only. I've been doing a lot of searching and i am thinking going with non-ic pistons. Question is, anyone know the Cummins part no. for these? Or any other suggestions? any input...

Anyone run a 1480 slip yoke on a 241DLD? If so care to share where you got it because i would like one. thanks

Hey guys, I got a 96 12v puller that i have taken the wiring harness out of the truck has been a work in progress and I'm hoping to pull this weekend for its first time. My question is i have a tach that i had in my old mud truck it was a gasser. Can i wire it in to the factory pick-up sensor...

hey guys im the new guy from SE, MN been readin on here a lot just finally got the account activated. I got nothin special for a truck just another 12 valve pretty much stock but hope to change that in the next year. This is an awesome site lots of great info, thanks guys