Recent content by KingS

Not sure if this has ever been asked on here and search function doesn't work on my phone so question is: What all is needed to add cruise control to a 2003 ST model with 5 speed. I know the 04.5 and newer most the time you just have to buy the switches but the 03-04 st are different and not...

has anyone found a place to get a factory replacement besides dealer to replace the main dash top once they crack? I heard Geno's but I've looked and website only shows the cheap junk cover black plastic crap.

Looking for a bully dog triple dog downloader for my 2003 Dodge either without outlook monitor or with the outlook monitor and harness. must not be vin locked and in good working condition. easiest way to contact me is text (269) 414-6711.

Sorry before hand this will be long. Ok I recently bought a 2003 quad cab 5 speed. Story goes it ran then one day would no longer start. I buy it start looking it over and find the ECM to be bad and the FCA was broke, so I buy a used ECM matching part number and matching 5speed 2003 etc and...

Who can do a ECM reflash if I end up needing it done. I bought a 2003 quad cab 5speed recently that's didn't run, got checking it out the ECM is bad so I bought a used ECM matching ECM number from same model and year truck. Now I'm not to familiar with CR trucks but I'm assuming I will...

I'm looking for a 1996-97 cclb 4x4 roller. It doesn't need and engine or transmission in it but must be clean not rusted out or busted up dash etc. Or a rust free cab cab can be 94-97 but has to be club cab. Preferably somewhat close to Michigan but show me what you got. You can also text me...

Just like the title looking for a edge juice with attitude for my 98.5 dodge 24v. Text me with info. 269 414 9992

Hey there guys I am selling my 1996 dodge cclb 4x4 15,000 OBO if interested please feel free to make offers. Great truck has 299,000 on it and it dynoed 654hp right after TS race this year and since then I have benched the pump and went to bigger injectors This is my DD and I have driven it to...

Like title says I have a dana 70 open diff. Rear end, a stock fuel tank off a 95 , and stock output shaft that is perfect it came out of my trans when I had it built. All is forsale at make me and offer, best offer takes it I need ths stuff gone just don't low ball me. Text me for fastest...

For Sale .093 12v lines these a basiclly brand new I bought them put them on my truck ran it down the drag strip and not what I was looking for, so I pulled them back off. I am asking 400 OBO, I will have them with me at Schied's if you want them and you are down there.

Just wanted to say Had a good time racing in Muncie on Saturday it was fun went home with two 3rd places one in QD and one in E/T bracket. Also enjoyed the pulls I will be back next year for sure.

hey guys I can't remeber the rules for drive shaft loop. I know I need them and I know I need one on my rear drive shaft but that all I can remeber. My truck has the two piece rear drivshaft, and is 4x4. if memory serves my right I need three loops total, but not positive on that or location...

I have some stuff left that I need gone: dana 70 3.54 gear open diff. $500.00 stock rims and center caps $200.00 CIPA power tow mirrors $150.00 stock intercooler $100.00 stock chrome power mirrors $ 50.00 Must add shipping to all prices. PM or post up...

Ok guys I have set the timing on quite a few 12v's but never set one to higher the 19.5 deg. Here is my issue I was trying to time my personal 12v to 23 deg, I would get my mm of lift on the dial indicator where it is needed to be. Then I took the gear loose and the problem happens everytime I...

I have a 1979 Z28 Camaro for sale asking 13,000 obo for it is very nice interior and exterior has the 350 v8 with a cam and headers other wise all stock except craiger rims. This was my aunt's car had it since new she passed away and my cousin go it passed to her I have been storing it for her...