Recent content by megatron

Automatic: Suncoast competition M3GA 68rfe with their Billet triple disc convertor. Motor: 6.7 cummins, Mahle forged and coated pistons, 12 valve rods, "Bullet cam" street/race, 10 mm cp3 Exergy stroker pump, 45% (100hp) exergy injectors, ported head with valve job and 110lb Hamilton springs...

NV 4500. Has big Billet input from Valair. Shifts fine no grinding. $1750

Selling my steed speed t6 24 valve manifold off Megatron. $500 shipping included

Two frozen boost type 17 intercooler welded together. One end of each intercooler was cut off flush and then welded together to make the intercooler look like it did as the original except better. I was very pleased with the job this intercooler done but time to move to bigger and better. $400

I have TWO Fass 260 lift pumps off of Megatron. Both in excellent working order. Replaced them with a mechanical lift pump. $500 a piece

DRW dana 80. Has haisley 300m 37 spline axles. Haisley Billet spool. 4:88 ratio. Pulling Products rear cover/girdle. Billet caps holding spool in. Spicer 1550 yoke. Comes with brand new never used 8 lug billet aluminum hubs as well, weigh 7lbs a piece. Ready to bolt/weld in and go pulling...

Hart's latest 2.6 gt55. Has 12 runs on it and is in excellent condition. Comes with guillotine. $3000

Just need a good 6.7 cummins crank asap. Would also like a 6.7 bare block but I can probably bore mine out and sleeve it if I have to. 6602165453

This right here tops it off. REV MAX Transmission has finally broke my crank on my 2012 6.7 Cummins. Broke my fly wheel a couple weeks ago. Broke the carrier bearing clear off the frame 2 weeks ago. Broke the billet input shaft a couple months ago and sevaral other conponents in it. And last...

Brand new In the box data logger with blue lcd screen monitor. Was going to put it on Megatron but decided I don't need it. $2500 660-216-5453

2015 PPL Legal 2.6 turbo. T6 flange. 12 hooks on it. Currently has 32 cm exhaust housing but I have available a 25 and 27, your choice. Comes with v band clamp on billet guillotine. $3500 660-216-5453

This is the complete short block from Megatron. Its still a wet block (not filled) - custom made billet pistons from D&J Precision 14:1 with .250 valve reliefs - total seal gapless rings - 12 valve shot peened rods with clevite bearings (6 hooks) - 6.7 crank with clevite bearings as well (6...

Well boys... its time to part with Megatrons power plant. Me and the wife are expecting June 30th! It'll be sold as a complete long block. Motor is ready to set in and rock and roll. - 5.9 block bored .040 over - 6.7 crank putting displacement at 6.1 - 12 valve rods - billet aluminum...