Recent content by scottsjeeprolet

Unlocked in great shape S03. $400 shipped to the lower 48.

They just stopped working on my 99. Where to start? Everything else works, runs great.

Less than 2000 miles on since i had them checked at F1 and installed. I'm dropping down a size so i can pull my big Azz camper. $500 shipped to the lower 48 states.

Still got these. They are rated @ 80hp @ 150tq. Got a set 24V 2nd gen that are fresh back from Don M. I would like $350 shipped. They ran great in my truck and will be a very nice improvement over stock injectors. Here's what Don said about them. "Couple of things: These are a used injector. I...

Got a set 24V 2nd gen that are fresh back from Don M. I would like $350 shipped. They ran great in my truck and will be a very nice improvement over stock injectors. Here's what Don said about them. "Couple of things: These are a used injector. I would be pretty confident is saying they were...

I've got a HX35 off my 99 with only 91K on it. No shaft play. Always cooled down to 300* with turbo timer. The exhaust ports have been ported. I sand blasted the cover to clean it up. Might want to hit it with some clear coat so it doesn't corrode. $300 shipped to lower 48 states only...

:blahblah1:

I have a set of DDII's for VP truck. Nice injectors over stock. $300 shipped. I recommend new washers & orings. Wheel simulators for 7 window Dodge wheels. One rear is a little messed up. But all 4 for $150 obo, shipped to the lower 48 states.

So how can you tell if you have a set of Mach injectors. They only have numbering on them. Is there a part number that F1 puts on the injectors? Looking at a set of Mach 3's.

Got a set of Hamilton 24V springs. Bought them, don't need them. NIB never used. $250 shipped to the lower 48 states only. Also got a set of Dually simulators for 01-02 eight window wheels. Won't fit my 99 four window's .:bang Decent shape, one rear is messed up on the outer lip.But the...

So i need to try some custom tunes or any ideas on what to try now. I've got a friend that has the AD too and i want to try his out this weekend & see what it does. Hope it's not the pump! The truck breaks up at upper RPM's, like hitting a rev limiter in a gasser. I've got a set of valve...

I cannot find this freakin ujoint anywhere. I went to the dealer and they even looked it up by the VIN and it was the wrong joint. :bang None of the local parts places have the correct joint either.:doh: It's the Front drive shaft front joint (@ the yok) for my 99 3500. Anyone know the Spicer...

Well this is starting to tick me off. I bought a HX35 60mm compressor housing and it doesn't have the bracket for the waste gate. I also bought a HX35. The housings are the same just different machining. Has anyone machined their own housing and do you have a drawing or specs. The 60mm housing...

Well i just got this 35/40 center section today and am concerned about the missing bits on the OD of the Compressor wheel. They don't look to have been cut out for balancing purposes. What do ya'll think, should i run it or try to send it back. Also will this fit my stock HX35 compressor...

I've got a friend with an 01 and it's almost due for it's 75K injector swap. It has 230K and he says he has to change the injectors every 75K and now it's out of the 200K warranty. It's a 3500 very heavy work truck & tows heavy almost every day, so what are the options for aftermarket...