just bought a 1206. trying to get it cranked, has been sitting for several years- turn over good, got good fuel to pump but not out of injection lines- how hard is it to open this pump up?
yesterday i ran it pretty hard up a hill and it went into limp mode but didnt die. set a low rail psi code- cleared it with scantool and was fine until today- driving on level ground, it died. checked codes llow rail psi again. let it set for about 15 min and tried to crank- no luck. think its...
just installed a dr P race module rail psi and new press relief valve. ran good first 3 runs now it wont get over 2g and bangs out. was clean putting press relief in and o-ring was reused but good shape
New in box bullydog outlook monitor, sent me wrong one, has gm subharness but will work on 06-07 (doesnt need subharness)( also posted in gm section) call me on my cell (325)-998-4186
Diablosport predator new in box, sitting on my shelf way too long, make an offer. also bullydog outlook monitor with gm subharness (fits gm except lmm, 06-07 dodge, 6.0 ford) also new, make reasonable offer. call my cell (325)-998-4186 thanks steven
does anyone have info on parts to swap a 3208 into a chevy or ford (adaptor plates, bell housing, etc). Before yall start to laugh too hard, keep in mind that the motor is free and it runs, it will be a sled puller, just for good times sake