Recent content by trucken

Need Scan tool- Balance test inj.- near Tampa Think I have a over fueling injector. Hoping to find someone with the scan tool to do balance test on new injectors to determine my issue. Like to find anyone in Tampa area to do this. Any ideas who can? Thanks 2004 5.9

Looking for 150 over cr injectors for my 2004 (early) RAM. Good Inj. only! capt.wahl@gmail.com What you all got. Can't pay Ind Inj kinda money.

Need a specialist in cummins performance in Tampa Bay area. I can't seem to find any recomendations. Don't want to pay for techs learning curve, and experimentation, or parts replacement mechanic. Historically I've only used ATS in Denver, Scheid Diesel in Terra Haute, or Kurt Lincoln in...

2004 RAM 2500. yesterday stumbled, RPMs lowered to 500 then stalled. Towed home. Checked fuel; OK Checked FASS150: 14+ PSI Changed rail psi sensor, and blocked off rail psi relief valve. Nothing runs.. Disconnected 1 of the inj pumps it ran but rough, fuel rattle. Swapped using other PPE CP3...

2004 RAM 2500. yesterday stumbled, RPMs lowered to 500 then stalled. Towed home. Checked fuel; OK Checked FASS150: 14+ PSI Changed rail psi sensor, and blocked off rail psi relief valve. Nothing runs.. Disconnected 1 of the inj pumps it ran but rough, fuel rattle. Swapped using other PPE CP3...

Lenny Reed, Owner of Dynomite Diesel is TAKING advantage of the Bosch National Shortage of Dodge CR injectors by adding $500 to a set of 6 Just because they are in shorter than usual supply. Sounds like a good time to screw your customers who have stayed with them through thick and thin times...

2004 Cummins, Twin turbo, nozzles, dual CP3. Was running fine when all of a sudden, Coming down the hwy, started stumbling, missing, running like $hit, smoke pouring out from behind truck. Ildes very poorly. Smokey BAD!! No excess level in Oil. Turbo area looks oily! Its leaking oil from...

Greg, Can it be done? 24v CR

Need fan shroud from 2003-2004 ONLY! Good Shape.

I've been running wide open for too long... Nobody wants to stop at a light next to me. Sounds like a cruise ship exhaust next to your ear. The worst part is the harmonic hum at highway speed while towing. The constant drone is rough. Time to quiet it a little. Just a little...:clap:

Been throwing a code lately saying something about CP3 Controller fault. Anyone got one?

just did head gasket and studs. After assembly turned up the tune a little. Jumped on it a bit, got a bop, bop, bop kinda miss. Only thing I can think of is lash was a little loose (I notice while re-assembling) Figured I adjust later after running a while. Any Ideas? A look below will show...

I busted my fan shroud, and need another. Anybody recently put on a Flex-a-lite Elec. Fan and have a spare Shroud to sell cheap? THANKS

I could most likely figure it out, but. Sure would be nice if I only remove the very minimum parts to do this job. Any ARP 247-4202 step by step instructions anyone has laying around maybe they could email them to me? Streched the old ones at 80-100 lbs of boost. Oh well it took 2 yrs of drag...

2004 Dodge 2500 LB 2WD AUTO Launches very well, pulls very strong, 2/3 down the strip pedal unresponsive engine does not stall, but I have to coast across the finishline. It sucks. Its still running, I drive it to the start line it seems fine but, next race it flatlines again. I change the...