Recent content by Whitenightmare

Well, gotta pay to play. Blew the head gasket on my 12 valve. Coolant POORING out on passenger side. Felpro gasket, stud nuts torqued to 125 ft pounds. Should I torque it more? That’s the spec that the kit from opti torque said. Should I o-ring it? A local machine shop says they can cut the...

Alright, 01’ vp24v , nv4500 , 4x4. My transfer case fluid keeps on sneaking into my transmission! I fill my tc with atf till it runs out the fill hole. I fill my nv4500 with the Gm spec fluid ( that I assume based on price is squeezed from diamonds) . I drive 400 miles and the trans is...

Does anyone know the dayco part number for a RIBBED tensioner pulley. I put a 12v in a obs Ford that is a factory no a/c truck. The belt route for no a/c puts the ribbed side of the belt on a flat/ smooth pulley. I’ve search my ass off and can’t seem to find a solid answer. And unlike my new...

Not sure if the pic worked but it he tag says Bosch 903 ( I think) it’s on a 12v that I’m considering buying but don’t want to get stuck with a boat anchor

Anyone have a good experience or recommendation for re attaching the metal “hinges” to the glass on extended cab doors? I tried pc7 2 part epoxy and they stayed together for about a month. Fell back apart today. While we’re on the subject. Does anyone sell the latches? Anyone have a set of...

I’ve seen a few good looking iPad dash setups for 2nd gens on the internet but can’t find anything about them. Does anyone make a custom dash mount that puts the iPad over your stock gauges? If not I’m gonna probably try and build one . I am about to install the quadzilla adrenaline.

01’ 2500/24v/ nv4500 swapped/ 4x4 / edge tune Both batteries are 2 years old and test hood. SERP belt is tight. Truck starts no problem at all BUT ... immediately after starting it starts charging, then stops for 30 seconds, then charges for 30seconds , then starts charging again and...

Hey guys, it’s November , time for heat to work.So I Swapped my heater core today . Got it done in less than 2 hours by cutting the metal pipes on the old and new core and reconnecting them with hoses and clamps. This made it possible to replace without pulling the hvac box. Just the dash gets...

All parts are from a 01’ 2500 24v -47RE (NEEDS COMPLETE REBUILD) good core, deep sump pan -auto brake pedal -auto transfer case input shaft -flex plate I also have a 2010ish (G56) complete (but used 10,000 miles) clutch kit aftermarket non-dual mass flywheel! Was only replaced because the owner...

Hey guys, I’m planning on a 2” leveling kit on my stock suspension, 01’ 2500. Do I need an adjustable track bar also?

Anybody ever figure out a way to tell if the KDP has been addressed on a new to them truck. I’d rather not pull the timing cover to find out it’s been done. Any luck with an inspection camera? I haven’t tried but wondering if I could get in there. Or is there some easy way to tell that I don’t...

New here, my name is Dan Warner, I’m a auto mechanic in Chester county, pa. I recently picked up a 24v dodge that I plan on doing a nv 4500 swap to, then a P pump. Then... when it’s all running the way I want , swapping the whole drivetrain into a 89’ f350 that’s been my daily driver for years...