A1 Technologies 14mm Head Studs Broken

I heard they were closing down and going over seas. This was coming directly from ARP. I guess you could call Haisley and ask them if that holds true.
 
A1 studs is moving over seas and will no longer be an option.

However, there should be companies that have plenty of residual stock around the country.
 
Talked with Haisley, they have a few left on the shelf, once they are out there done with them. They will only use ARP after that.
 
The ones I have don't have the hex to install them. They do have A1 stamped in the ends. I have 3 short, 6 medium and 4 long. Make me an offer. Take 1, 2 or all
 
Last edited:
looks like they're not long enough... and the hex looks a little large, but the bottom line is if the nut were farther down on the shank, they probably wouldn't have broken.

bummer
 
Measure the length of the stud and if I can get to the shop tomorrow I will measure the ones I have and see if they are to short
 
You must log in or register to reply here.
Back
Top