more pictures:drool1:
The primary will be fully supported, I'm just concerned with the heat eating the pipe up.
Don't see any room for a flexi pipe.
i agree:rockwoot::rockwoot:
I can tell you that .375 wall 16" pipe will start to balloon at roughly 2000psi, but don't ask how I know. LOL
hmmm did someone mis-spec the pipe and use S30 where S40 or heavier should have been used??
roachie if you have the inside of the pipe coated then you shouldn't have any issue with the temps eating up the pipe. if you coat it on the out side of the pipe :bang i'll smack you myself!:kick:
as for air being the best insulator that is only for still air. in this case you have moving air which is not an insulator. read your heat transfer book again!
I'll start my own thread hopefully this weekend after I get some video and run time on them. I don't wanna de-rail what is shaping up to be an informative thread. :rockwoot: