inline6359
Microwaving cats since 01
- Joined
- Aug 28, 2006
- Messages
- 2,043
Well i finally installed the stage 2 injectors smokem showed me but i canno give an accurate opinion or ride review on them until i get some thing ironed out.
1. I installed the injectors put it all back togetherand come to find out that injectors 3,5,6 and DV 1,5,6 all leak. I torqed them to factory specs. My question is does anybody else tq thiers to factory or do you just tighten them down?
2. Now my truck idles rough, if i sit at a red light long enough it kind of shakes a bit. I dont know what would cause it. I also put my buddies new overflow in to eliminate that possibility and it didnt really help. also the roughness get faster as rpm's increase but once you get to about 2700 you cannot feal it. again WTF?
3. If i were to sit there and dead rev the truck before it would sputter at just after 2k it still does this but now it does it every once in awhile while driving down the road. also with my 4k kit once i stand on it it startes to spit , sputter and put out white smoke at 3200 and will not rev any higher. I am still stumped, i have also noticed that once i get to about 2800 the pedle becomes harder to push. does this have anything to do with contact with my fuel plate?
i am not sur if all of this leads to the fact i have not tightened my injectors yet because i have not had time or if there is something else. i will tighten them in about 3 hours from now and let you guys know.
Also smokem, i need to pm you when you are on, i removed that piece we talked about in the pump and at first the truck ididnt want to idle and now when i start it up the idles is about 500 or lower could removing that have anything to do with the above problems.
anyhelp is great because these are driving me insane.
rick
1. I installed the injectors put it all back togetherand come to find out that injectors 3,5,6 and DV 1,5,6 all leak. I torqed them to factory specs. My question is does anybody else tq thiers to factory or do you just tighten them down?
2. Now my truck idles rough, if i sit at a red light long enough it kind of shakes a bit. I dont know what would cause it. I also put my buddies new overflow in to eliminate that possibility and it didnt really help. also the roughness get faster as rpm's increase but once you get to about 2700 you cannot feal it. again WTF?
3. If i were to sit there and dead rev the truck before it would sputter at just after 2k it still does this but now it does it every once in awhile while driving down the road. also with my 4k kit once i stand on it it startes to spit , sputter and put out white smoke at 3200 and will not rev any higher. I am still stumped, i have also noticed that once i get to about 2800 the pedle becomes harder to push. does this have anything to do with contact with my fuel plate?
i am not sur if all of this leads to the fact i have not tightened my injectors yet because i have not had time or if there is something else. i will tighten them in about 3 hours from now and let you guys know.
Also smokem, i need to pm you when you are on, i removed that piece we talked about in the pump and at first the truck ididnt want to idle and now when i start it up the idles is about 500 or lower could removing that have anything to do with the above problems.
anyhelp is great because these are driving me insane.
rick