One of the freeze plugs blew out of the cp3. In this picture, one of the barrels is stuck in the cp3. The other 2 came out but I terribly chewed up. Look at the freeze plug hole in the center of the picture. you can see where metal knocked around in there.
This is a chewed up "piston" out of one of the barrels. LOOK at that!!!!
The one on the left is supposed to be just like the one on the right....oh but wait, half of it is missing!
Gotta give mad props to this guy. This pic was taken at 1am last night. He started working on my truck at 9 the morning before. Installed new flexplate, went for test drive, blew my CP3, installed a new cp3, installed a new tie rod on my truck, pulled all 6 injectors and rail and cleaned them. As of last night when I left, he had pulled 4 of the 6 again. Thats dedication, i don't care who you are. 5 and 6 were still mis-firing. When the injector plug to 5 and 6 were pulled, the truck runs just fine. 5 & 6 plugged in, it has a fuel knock from the cp3 debris stuck in the injectors.
Today, 5 & 6 will be pulled and taken apartment. The injector bodies will be torn down and will sit and soak a while, then re-install and hope for the best.
All of these pics were taken off my cell phone. I plan to get better pics when I go back to get the truck.