bigstacks95
Diesel Doc
Does anyone know if they make housing studs for the 20145 where the 3rd member mounts? I figured it would make life easier for sliding it up in there when the time comes
Narrowing a Rockwell
- Thread starter bigstacks95
- Start date
Persingerpulling
Tryin
In semis I use two long bolts with the heads cut off to get the pig aligned and slid in.
Inbred Inline
Bastard child builder
Not from what I've found, talked to kennys at Gordyville and he said the same.
Sent from my iPhone using Tapatalk
bigstacks95
Diesel Doc
Does anyone have torque specs for a 20145? Looking for:
Saddle bolts
Pinion nut
Carrier bolts
Saddle bolts
Pinion nut
Carrier bolts
Highfinance97
Garofalo Enterprises
Pinion nut-1350' (sounds about like 9-10 ugga uggas from the big gun)
Pinion bolts-75'
Caps-650'
Carrier to housing-75'
bigstacks95
Diesel Doc
Thanks, babe! :cheer: :cheer:
CorneliusRox
Seasoned Rookie
1350 ftlbs! Get out that torque multiplyer! :lolly:
bigstacks95
Diesel Doc
Some more stuff, modded some stock aluminum hubs to fit on a set of real wheels with the centers cut out to pilot on the back of the hubs. Real happy how this is all coming out.
Sent from my SAMSUNG-SM-G890A using Tapatalk
Sent from my SAMSUNG-SM-G890A using Tapatalk
Inbred Inline
Bastard child builder
Some more stuff, modded some stock aluminum hubs to fit on a set of real wheels with the centers cut out to pilot on the back of the hubs. Real happy how this is all coming out.
Sent from my SAMSUNG-SM-G890A using Tapatalk
Wow that does look sweet, I like that a lot.
Sent from my iPhone using Tapatalk
bigstacks95
Diesel Doc
Thanks, I put ten 1/2" grade 8 bolts and nylock nuts on each side, hopefully it doesn't go anywhere
Inbred Inline
Bastard child builder
I don't have any real weels and too cheap to buy a set this year so I have some 17" steel blanks in gonna weld a 10 bolt center in for my inners, then my regular 8x6.5 aluminums go on the outside.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
bigstacks95
Diesel Doc
what are you using for an adapter on the outers? Proformance pros? Looks like the newer Chevy/GMC 8x180 pattern is REAL close. I might try to get a set of wheel adaptors and throw them on the Bridgeport and make them work.
Inbred Inline
Bastard child builder
Glen Rotman at ED is making them for a few of us here in Michigan
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
bigstacks95
Diesel Doc
Very nice!!!
jones95runner
New member
That's how ours are done. We run 1.5 worth of spacer inside and out and use the same wheels inside and out. We have 3 trucks down here with same setup with probably combined over 500 pulls and no issue with them. Ours have been done that way for 5 years now. I don't think you will.have any issue!
