ahale2772 New member Joined Oct 27, 2011 Messages 2,442 Feb 26, 2014 #1 Does anyone know the spicer part number for a 1410 front driveshaft yoke for an np271?
kleann VP44 pwr Joined Aug 23, 2008 Messages 4,388 Feb 26, 2014 #4 You're welcome. We had to machine down the stock yoke and dirt cover to fit with that yoke, iirrc. But i don't know of any other bolt on yokes.
You're welcome. We had to machine down the stock yoke and dirt cover to fit with that yoke, iirrc. But i don't know of any other bolt on yokes.
ahale2772 New member Joined Oct 27, 2011 Messages 2,442 Feb 26, 2014 #5 what do you mean the stock yoke and dirt cover?
kleann VP44 pwr Joined Aug 23, 2008 Messages 4,388 Feb 26, 2014 #6 http://quad4x4.com/images/qu11012sj_small.jpg it's been a few years since we did it, but believe had to cut this piece in half almost and use it for the dirt cover. Last edited: Feb 26, 2014
http://quad4x4.com/images/qu11012sj_small.jpg it's been a few years since we did it, but believe had to cut this piece in half almost and use it for the dirt cover.
ahale2772 New member Joined Oct 27, 2011 Messages 2,442 Feb 26, 2014 #7 Ohhhh so what your saying is you just added the dirt shield to the 1410 yoke
kleann VP44 pwr Joined Aug 23, 2008 Messages 4,388 Feb 26, 2014 #8 ahale2772 said: Ohhhh so what your saying is you just added the dirt shield to the 1410 yoke Click to expand... Yeah that part number is just a regular end yoke. It's the best I could find after researching.
ahale2772 said: Ohhhh so what your saying is you just added the dirt shield to the 1410 yoke Click to expand... Yeah that part number is just a regular end yoke. It's the best I could find after researching.
ahale2772 New member Joined Oct 27, 2011 Messages 2,442 Feb 27, 2014 #9 10-4 i just picked one up. Ill play with it And report back on how it all works.
ahale2772 New member Joined Oct 27, 2011 Messages 2,442 Feb 27, 2014 #10 So the yoke itself is the correct spline, but too short, so i chucked the ford flange on the lathe and parted a section to use as a spacer, that conveniently has the dirt shield on it. The ford shaft itself is what the seal rides on. Thanks to kleen for the PN!
So the yoke itself is the correct spline, but too short, so i chucked the ford flange on the lathe and parted a section to use as a spacer, that conveniently has the dirt shield on it. The ford shaft itself is what the seal rides on. Thanks to kleen for the PN!
kleann VP44 pwr Joined Aug 23, 2008 Messages 4,388 Feb 27, 2014 #11 Yep, just like I did it. I knew you'd be able to figure it out!