kalder
Kevin Alder
What spray angle did you go with on your injectors with those pistons?
145 degree VCOs.
What spray angle did you go with on your injectors with those pistons?
According to mahle they were released a couple of months ago. Coated skirts and flycut straight from the factory. No outsource of any type.
it looks like part # 286050 on top, is thet what they are, then fly cut and coated? is there a part number i can give my vendor?
Everybody told me I was wrong for buying those pistons, now 2 years later people are buying them....odd!
Jim
so if you make it shorter/shallower by milling the top of the piston down you raise the comp.
Our PN# for the kit (flycut 286050) is 9300366xx (15, 35 or 55 depending on oversize). For the distributors, we have them set up as complete kits (pistons, pins, clips, and rings). If you needed just the pistons it's something we'd have to sell on a custom basis.
What? lol
Here is the general info Eric gave me on the piston Brad posted;
Flycuts 0.150" deep
Bowl volume w/pockets 59.2cc
Estimated CR 14.0:1