Turbo coatings

[jfaulkner]

Aesthetic Finishers (http://www.afipowder.com) did these


Kennametal did these.


Both have been running for a while and both look like the day they were done.

 

[DieselheaD]

Bc847 that stuff looks great! One of the best looking compound setups I've seen btw.

 

[newsmoke]

Pretty sure the hot pipe is a factory Cummins part. I can't remember if it was in the magazine write up or not

 

[97rada]

Pretty sure the hot pipe is a factory Cummins part. I can't remember if it was in the magazine write up or not

That would make my day! Any idea where you saw it

 

[newsmoke]

Call Jeff moocow or mumau or however you spell it. Pretty sure my 5.9 bus motor had one. It's called a cobra head elbow

 

[BC847]

It's called a cobra head elbow

Stock/OEM on the Cummins N7? Not sure which engine. Cast iron.

 

[newsmoke]

My engine was an isb 5.9 but I cannot remember if the cobra head was sheet metal or cast

Sent from my C811 4G using Tapatalk

 

[camarokiller]

More ppl need to know about that. Wonder if i could make that fit in a side by side setup.

 

[homewrecker]

Tip for getting anything coated is to be rust free prior to applying. Jethot is known for not holding up. Quick Google search will reveal that. Cerakote is a good product. Used by lots of coating shops nation wide

Sent from my Nexus 7 using Tapatalk

 

[newsmoke]

More ppl need to know about that. Wonder if i could make that fit in a side by side setup.

It's pretty costly if I remember correctly

 

[97rada]

It's pretty costly if I remember correctly

Not when you work there

 

[90dodge]

Part # for the cobra elbow is 3927862 I think. They came off generators I believe.

 

[Win slow]

I finally got my coatings they didnt make it the first time because of a minor mistake on the shipping address but cerakote took care of it and sent a replacement right away. I have to say they have been very good to deal with. I will try to post pics once its all done.

 

[Win slow]

I got the stuff all done it was fairly easy to apply and looks sweet. Only time will tell how it holds up, it does seem to be pretty durable. Also pics of my pistons I did a while ago.

 

[Win slow]

more pics. I got a few funny bubbles on the big chargers exhaust housing it was a used turbo and was pretty rusty i should have put it in the oven again before coating it to "degas" it i think that was the issue. All the parts were baked in the oven at 450 before coating this is part of the process.

 

[Ghostman]

Be interesting to see how it holds up


Sent from my iPhone using Tapatalk

 

[Drothgeb]

I've had good luck with Cerakote.

 

[biggy238]

In for pictures after some full bore pulls