Recent content by strokin6L

Bulldog5.9(Dominic Gambino) of Brothers Diesel at Erie County Fair in Hamburg NY...took first place! http://www.youtube.com/watch?v=BnYQ_8ENbms

is it possible to put studs in a 6.4 by installing them one at a time while leaving the cab on? And if so...how hard is it? Kid in my area wants to install studs on his 6.4 during his winter break and wants me to help, but his plans are to install them one at a time with the cab on. Honestly...

Anyone know where the a/c high pressure switch is? I installed a set of 7.3 electric flex-a-lite fans on the truck and it says to tap into the A/C, but was told that it should be on the high pressure switch. Not sure if it's the one up next to the heater core or the one on the A/C line down...

Joe gambino of brothers diesel performance winning prostreet class at langford NY. Points leader in the club http://www.youtube.com/watch?v=9FrGl1lCWtI

I wanna get rid of the plastic piece above the turbo that is clipped to the cowl. I'd like to see pics of you guys that have done it. Both tabs are already broken and that damn thing is always in the way so i just wanna remove it and maybe use like heat tape to wrap the wiring harness and tie...

just got some new eye's for the truck...some eagle eyes that is. Got a set of '05-'07 harley headlights and they fit really good and look pretty good to i think. Got them off of ebay for $160 and they came with the adapter harness' to plug right into my factory harness and the directions on...

is there any company out there has makes socks or sleeves to slip over a mitered stack so that water wont get in it?

got rid of my two 5" stacks and installed a 6" single

Well guys here's my truck pull vid from an hour ago. I had awesome wheel speed but couldn't get hooked. I did a 10lb boosted launch and then graped it. I started out in second gear then shifted to 3rd. I thought i popped the turbo at the end, but ended up being just an intercooler hose...

It's been a while since i took some pics of the truck....so thought i'd post some.

Anyone running opti-lube's XPD summer blend attitive formula and their 2 cycle oil in the fuel?

I just installed a FASS 95 series system on my buddy's '05 6L that is a stand alone system and eliminates the factory pump(HFCM). The FASS system is said to put out 50psi but the fuel pressure gauge reads 66psi. I started it up and let it idle for a little bit then drove it around the block...

Alright, has there been anyone that has had a problem with their II turbo leaking oil? Found out with the help from redneck6.0L that it's pushing oil through the compressor side and turbine side cause the drain line isn't large enough for the oil drain flow. Oil is also seeping from where the...

I have LIPD's regulated return system on the truck now and am gonna probably get the FASS 150/180 and eliminate the factory pump and engine mounted fuel housing. This kit removes the factory hard lines and replaces them with braided stainless lines going from the engine mounted filter housing...

Hey guys! just became a member. I'm also a member of TDG but though it would be good to become a member here also.