Im gonna find out what my racked 180 can do in a couple weeks after a local shop balances it. If you can wait ill have results for you.
Sent from my DROID3 using Tapatalk 2
Where you planning to dyno at?
Phil Taylor did low 900s with a 12mm a while ago.
I have a 12mm pushing 700cc and will see what it does at TS.
that pump is on my truck now...
Whos pump?
"Mikes custom trucks" in northwood, nd. Its 30 mins away, the next closest one is 2 hours. If I get back down to snyders, id like to run on his too.
Sent from my DROID3 using Tapatalk 2
Wimers injection, it is a local shop in pa. I hope the twins will clean it up and with my cam they should light fairly quick.
Don't plan on very accurate numbers. He usually does a spring time dyno/sled pull. There are a bunch of guys that wont dyno there anymore because of the way he runs it. He wont load the dyno so if you've got a somewhat big turbo or twins you don't build any boost and end up with crap numbers.
I've heard that before. And he's way overpriced. Do you anyone else who'll run a diesel? Are you from the area?
I might be making another 8 hour trip to iowa after all LOL
Go to his website and look at some of the past dyno days. The trucks are listed with the mods and the HP. Some made a lot less HP from the dyno down in the cities. We used to dyno at Hitech in Elk River, MN in the fall but the owner doesn't like smoke and won't dyno diesels anymore.
These guys are supposed to have a dyno. The owner is an NTPA puller. You rent the dyno by the hour. You run yhe truck, they help.
Gueningsman Automotive Specialist
(320) 485-39942503 225th St, Winsted, MN 55395-6551
If you're up for the drive Chris won't steer you wrong either. It's just a long drive. About 5 hours for me, 6 if the wife and kids come with.
Mike overpriced? Say it ain't so, I could never believe it.
I'm about 50 miles SW of Fargo by Fergus Falls. You should check out http://www.midwestdieselconnection.com and THE Diesel Truck Site! . They're not very big but a good place to BS with the locals.