Numerous ECMs for sale! 2001-2007

Do you have the ability to share the pinouts on the 2006 ECM and possibly the plugs where the harness hooks to the valve cover harness. Fighting a 123 injector codes that comes and goes as well as the 456. New injectors and VC harness. Im wanting to check the harness. before commiting to an ECM
 
I haven't gotten that far on it, yet.
I'm wanting to piece together a guinea pig engine, since all I really have is some nice cores, but nothing trustworthy to run.

Between the parts thing and trying to appease the local "clean it up" nazis, I'm pretty tied up.
I still have to finish up pulling 2 VP engines, then run to CSnyder's and Indiana over the next 2 days. :bang

Mark.
 
Oh, yeah, meant to mention that the following 2 ecms are SOLD!!!

3936242, 2000 5 speed manual transmission...

4931980, 2007 automatic trans....

Mark.
 
Still have the following ECMS:

3963994, 2003 manual transmission, $250 SHIPPED.

3971104, 2004.5, auto trans., $275 SHIPPED.

3971105, 2004.5, manual trans., $275 SHIPPED.

3971608, 2005 auto trans., $275 SHIPPED.

4931975, 2006 auto trans., $375 SHIPPED.

4931978, 2007 manual trans., $375 SHIPPED.

PM, reply, or call 402-780-5127.
 
Picked up a few more of the CM849 (2006-2007 5.9) ECMS recently.

Mark.
 
Mine was happy and fired the engine last night. Thanks again Mark!
 
Mark,

I am interested in this ECM, please advise if this is still available, also best method of payment ( I am paypal ready)

- 3971105, 2004.5, manual trans., $275 SHIPPED.
 
CMIIW, but I think a person with under 10 can POST (and read), but not PM.

Mark.
 
Pm sent , need the 06 ECM , let me know if you can get a 05 harness
 
Mark,

I am interested on this, I recently joined this forum thus I am not able to PM. Please call me 6262134448 to discuss.

- 3971105, 2004.5, manual trans., $275 SHIPPED
 
I'm interested in the 06 ECM . Been sending pm's please let me know yes or no if you still have one
 
I said I had either manual or auto and that I could sell you a manual, since you want to do a standalone.
You then sent me a PM I couldn't make heads or tails of at 1PM yesterday.

Mark.
 
I would prefer the auto one that way I can still use my truck normally until I convert over to the manual valve body . I don't want to try and do everything all in one shot . Very interested , yeah I Couldn't figure out how to send the pm's correctly
 
If it's stand alone I'm not sure it matters but I don't want to convert my truck over to efi live with your ECM and not be able to drive it over to the trans shop for the vb swap and shifter install
 
Mark Nixon said:
Lavon,
I don't have any myself, but I'm finding a pattern that the VP trucks don't SEEM to differentiate between auto and manual on the ENGINE ECMs.

I was just on Car-Part.com and there are several listed there for a 2002 automatic, anywhere from $250 to $500.

Mark.
Click to expand...

Mark when I used the Auto ECM it will not allow you to go past 1900 rpm with out supplying a tail shaft speed input. It gets hard as that info is had via the PCM. So it's easiest to just use the Manual ECM ether 235hp or H/O but only on the 235hp Pump.
 
You must log in or register to reply here.
Back
Top