Recent content by 06RAMCTD

The culprit.... Thanks for the input!

No the oil pump has never been out. The injectors are good. Top end is ok. Looks like something got into the pump and locked it up. I have heard of this as a common problem. Need to check bearings.

Has anyone had problems with the oil pump failing?

2006 Dodge QCSB 3500 SRW 4x4 SLT w/ 42,XXX miles • S300 64mm rebuilt by Mumua Diesel (9/2011) • ATS manifold – ported • 5” turbo back exhaust – Magnaflow Stainless • K&N intake with Amsoil Dry Filter • Air Dog II 165 • Smarty S-06 w/ TNT-R (4000 RPM Rev Limit) • EEP Coolant By-Pass Kit w/...

As the title states, I am looking for a CP3 in the Western PA/ Eastern OH area. I would prefer to buy one from someone locally. Let me know, what you have. Thanks

What size are the fittings going into the heat exchanger? Can the large fittings in the exchanger be removed? Thanks!

Do you still sell the turbo smart system? If so, how much? Thanks!

I've been looking at these systems to protect my turbo at the end of a run. Does anyone have any experience with either one? I did find 1 thread about the turbo smart, but nothing on the BD system. Thanks!

I have a set of Trxus STS 33 x 12.5 x 17 I am looking to sell. $600 pick up only.

For sale is the stock turbo off of my 06. It had about 38,000 miles on it, when I pulled it off. It has no in and out play, and little bit of play side to side. $300 shipped.

Is there anyone in Western PA with Starscan? I live in the Slippery Rock Area, and work in Harmarville area. My truck is throwing 2 codes: P0148 (HPCR-high pressure common rail) and P0191 (Fuel pressure sensor performance). I scheduled an appointment at my local dealer for a scan, but I would...

Fueling Problems? How do I know if I have a bad FCA on a twin pump truck? Tuesday night and last night at my local pull, my truck would not fuel on the line. I was trying to build boost, but it won't build up, it just rolls coal and won't light the charger. We thought the lift pump was...

I know I've seen it, but I cannot find it. I'm looking for the wiring diagram that shows how to keep the ECM from locking the torque converter. I have the T/C lock up switch installed, and working on the street at low speed. However, when I am sledpulling, I don't believe the ECM is allowing...

As the title states, I'm looking for a rail pressure gauge with recall capability. Quadzilla no longer makes one for the 5.9, anyone have any suggestions? Does anyone know if the EFI Live for Cummins will be able to read rail pressure from the OBD II connector?

I installed an II 64 Silver bullet, and I keep getting an over boost code. I am running a Smarty and I have the wastegate turned off. Do I need a boost fooler?