biggy238
Active member
- Joined
- Aug 3, 2008
- Messages
- 10,983
You good.direct drive high and low huh
They put enough fluid back in it to get it to the plug again. No apparent leak.
Sent from my XT1575 using Tapatalk
You good.direct drive high and low huh
You sure it's not accurate?
Sent from my SM-G930V using Tapatalk
mine does that..usually its the connection on the back of the guage..if it isn't tightened beyong tight it reads funny. if its open itll peg out maxed. if its shorted itll fall to below zero. if its just partially high like yers id say the wiring is dirty or loose..
Cool, almost asked if that was at his place when I seen the picture on Facebook, backround looked familiar. The tank on front his too?Helping keep the lights on at Mayer equipment nice to finally meet you Chris