Recent content by 97singlecab

Im gonna be there running my new prostreet 6.4

Here is my 97 i sold a couple months ago And here is my new one.

chassis side bracket has 7 hole options per bar. center to center of each hole is 3/4" Axle side bracket has 3 hole options per bar. center to center of each hole is also 3/4" center line of crank is 23 3/4"

I finally have the front and rear ride height set on the prostreet truck im building. What im wondering is if any racers have some input on what kind of pinion angle I should set my truck to. As well as a good starting point for the 4 link bars. The rear setup is a chris alston chassis works...

I'm got a 93 truck i'm working on that has a leaking ksb. Its leaking fuel around the flange between the two torx bolts on the bottom. My question is can you pull that and reseal it with out pulling the pump? And if so does anyone have a part number for the seal that needs replaced. Thanks for...

Here is my 6.4 that were building to run in prostreet next year. Got a long ways to go to finish it but its getting there.

Need to sell my 97 singlecab The truck has a 98 motor in it with 150k on engine, Head has been o-ringed has new valves and valve seals with a custom 5 angle valve job, and is held down with 12mm ARP studs. Has 5k miles on head work. Truck has a 12mm 215hp pump that has been benched and maxed...

Not sure if this is a repost or not but Rudy is putting on his second annual dyno and track day on March 17th at piedmont dragstrip. We will be there with our mobile dynojet 224 along with drag racing all day and a sled pull that night. Event kicks off at 10 a.m. but as soon as we have trucks...

What are you guys doing to delete the fuel bowl on a 6.7 cummins truck. Is there a kit available. I did some searching but didn't find what I needed.

Not sure if this has been gone over before but I didn't find anything after searching. I swapped a 241dhd t-case out of an 02 into in my 97 dodge, as most know there was no way to hook up the speedometer. After some research I got ahold of dakota digital and hooked up there SGI-5c box. It takes...

I have a garrett gt4294 turbo with a 67mm compressor and a t4 1.0 housing. I would like to trade it for an s300 with a t4 mount as i'm wanting to go to twins. Turbo has less than 5k miles on it with no play.

I am putting on a dyno event on the 16th in greeley, co at Weld county garage. We were tossing around some ideas on how to get more people to come and thought maybe a jackpot would be good. The thought was 25 dollars to enter the jackpot all money goes back to the competitors. Winner gets 70%...

370 marine injectors need to get rid of these. 250.00

My steering wheel is starting to come apart and loose all its foam and its time for a replacement. Are there any aftermarket options available any one on here has tried? If so where did you get it?

There was some talk at the event that numbers were lower than expected on alot of trucks at our event. Even a truck we took dynod far lower than its normal numbers. I have been looking into this all morning with dyno jet and I hate to say our brake was hanging on the drum due to low air pressure...