Recent content by RJM06590

The 7.3s have an intake heater to help with warming the truck up. Anyone ever think to put one on a 5.9? Or does anyone know how much heat they put off? I don't want to put my grid heater in nor bump the timing down for the winter, but if I don't plug it in for an hour or two ahead of time it...

Anyone in my area want a decent reading truck cap for cheap? I have all the keys here's the link. If it doesn't sell soon I might scrap the damn thing. White Reading Truck Cap

The third Airdog 150 motor quit on me tonight. Some back ground, I installed the Airdog on my truck (it was used) when I got it about 3 years ago. It put out about 45 psi and was loud but worked. It lasted until July this past year and burned up. I thought it lasted a good while since I bought...

Hey just wanted to apologize for being offline for a few months. We had a huge crab and baitfish season and it took up every minute I had. I'm going through my PMs and will answer back tonight.

LOL ever see these? http://www.youtube.com/watch?v=bkmaByQrCTA

Bringing this one back up, anymore information on them? DD-able? Race Bearings - Competition Diesel.Com - Bringing The BEST Together

Selling my 94 Fummins to build another one. Im listing this from my phone over the road so bare with me. The truck is a 250, but has a dana 60 king pin solid front swapped in. It will also have a 30k original mile 12 valve in it by this upcoming weekend. The engine is bone stock, but can be...

Merry Christmas to everyone and thank you !

I have a nearly new less than 1k mile s472 from forced inductions that I'd like to trade for a s465. The 472 has the 83one exhaust wheel and 1.10 exhaust. Let me know what you have.

I have the compressor housing, exhaust housing, and a center section with no shaft or wheels. The compressor housing has been ground to accept a hose connector (was in a rush) and the exhaust housing is a wastegated 1.44/83 turbine. The turbo actually spooled very well with the large housing and...

Set of A1 HD rod bolts that were torqued once and the rods that I polished. The rods will need to be shot peened before use. $275+ shipping.

Anyone have one laying around? Didn't get a chance to call Jeff before their vacation.

Listing for a friend of mine, Banks six gun off of his 6.0 Powerstroke, 200 shipped.

These are titanium dual valve spring retainers and 10* steel locks. They are used and have signs of use from the previous owners valve springs. They do not come with the valve springs, but I will point the buyer in the right direction for a set of springs for them (they're $150). I'm going with...

I need a set of delivery valves for cores, can be 181's or 131's. Let me know what you have. I need one set asap.